How To Install Vinyl Flooring In A Bathroom

Installing a sheet-vinyl floor is a manageable do-it-yourself project with proper preparation.

Most bathrooms can be covered with one piece of sheet vinyl flooring which is sold in 6′ and 12′ widths, making it possible to install a seamless floor in smaller areas. To begin, remove the toilet. You can make a template of the floor layout using heavy glossy magazine or flyer paper and place over the entire area. Tape all these pieces together to form a full size pattern.

Next, in another room lay the new vinyl flooring on a flat surface face down and place the template on the vinyl. Trace around the pattern then cut the vinyl with snips allowing a half-inch oversize. Roll the vinyl up and lay it in position in the bathroom then trim to size using a vinyl utility knife. When you are ready to apply the adhesive, fold or roll back half of the vinyl into the middle. Spread adhesive on the sub-floor for one side of the floor following manufactures instructions. Carefully lay the floor back in place and roll vinyl into adhesive. Repeat the process for the other half of floor.

To ensure proper adhesion, roll from the centre out using a vinyl floor roller or a rolling pin. Avoid foot traffic for at least 24-hours to allow the adhesive to dry. When re-installing the toilet be sure to use a new Wax Seal, applying the wax seal to the base of the toilet before placing over floor flange. I should also mention that installation kits are available through flooring retailers that include all the necessary tools for this project.